• TNT Rescue Systems is a family owned American made Hydraulic Rescue tool manufacturer.

• We are located in Ashippun, Wisconsin.

• Please contact us and we will get you in touch with the proper representative.

• Our tools are distributed world wide, we have various departments across the United States that use our tools including several major metropolitan departments.  For a list of departments in your area please contact your local representative.

• Forever warranty means that TNT Rescue Systems will warranty all TNT manufactured parts for life or for the duration you own it, “no ifs ands or buts”

Our strongest cutter is the BFC-320 / EBFC-320D / EBFC-320-18V this cutter achieved a NFPA 1936-2020 cut performance of: A9/B9/C9/D9/E9 and F5

Yes we manufacture the Storm Surge 18 volt series as well as the Storm 2 dual 28 volt series.

The Storm 2 series cutters, spreaders and combi tools have two battery receiver ports each. Utilize a single battery and place it on either side of the tool to allow operator better positioning in tight working spaces. The tool can either be operated by one or two batterie’s. Dual batteries enable the tool to be used for an extended run time.

We use Milwaukee M18 8aH batteries for the Storm Surge series tools and Milwaukee M28 5 aH batteries for the Storm 2 Series tools.

The tool can either be operated by one or two batterie’s. Dual batteries enable the tool to be used for an extended run time. No degradation in power when used with one or two batteries. Batteries can also be changed while operating the STORM-D unit. Utilize a single battery and place it on either side of the tool to allow operator better positioning in tight working spaces.

Yes it can and will still generate the same power, cut force and spread force.

If one battery gets low the secondary battery will equalize out so both batteries will run in tandem
displaying the same equal charge.

Yes do supply a Inverter which plugs into either a 110V or 230V outlet. This inverter can only be used on the Storm 2 series tools.

30 Feet

• LEXAN Plastic

Aluminium

Yes, we do manufacture battery operated rams. The rams are available in the Storm Surge Milwaukee 18 volt and Storm 2 Milwaukee 28 volt series. The ETLS-40 / ETLS-40-18V is a two stage telescopic ram and the ER-40 / ER-40-18V is a single stage push and pull ram.

Yes, the SLCC-30 and ESLCC-30 is rated for a chain package and utilizes our CP-30 chain pack.

Each Sorm Surge and Storm 2 series tool comes with 2 x batteries and one charger.

• It depends on what material the user is cutting or spreading and the skill of the user but typically a full
  extrication on one vehicle can be accomplished with one battery per tool.

The Storm Surge and Storm 2 series tools are rated IP54 and can be used in the rain and wet conditions, if the tool has to be submerged underwater to complete an extrication, please contact your local Dealer for preventive maintenance and inspection.

• ISO 68 Hydraulic oil and 10W 30 for the motor oil.

• Premium gas is highly recommended with a fuel stabilizer to prevent any tarnishing of fuel lines due
  to long periods of non-operation.

• We make a COAX hot swappable coupler that runs two lines into one coupler which can be connected
  and disconnected under pressure

We have dealers and service technicians located strategically all over the world, they can be contacted through the “locate a Dealer” portion of the TNT website.